Multi Material - Materials (concepts) tutorial - page 2 of 6
Multi Material - Materials (concepts) tutorial - page 2 of 6
Multi Material (page 2/6)
Written by Mike | Posted on September 24th, 2007
Next Outline the selection a bit.
Finally add a Bevel to finish up the house model.
Still in the Polygon subobject mode, select the lower part of the house (the walls) and, under the Polygon Properties rollout, enter 1 in the Set ID textbox then hit Enter. This last part (with the Enter key) is very important, otherwise your ID may not be assigned.
iEntry 10th Anniversary 
Modeling 
Contact
